ASA is a fantastic ABS replacement. Its UV resistance is fantastic and this makes it perfect for Outdoor use.
eSUN ePA12-CF Nylon Carbon Fibre
A material developed by eSUN and LUVOCOM based on PA12, added with 15% carbon fiber, greatly enhances the strength, rigidity and toughness of nylon. Low water absorption rate.
A material developed by eSUN and LUVOCOM based on PA12, added with 15% carbon fiber to greatly enhances the strength, rigidity and toughness of nylon. This material can be used as a substitute for metal in many occasions! Due to it's low water absorption rate it's less affected by humidity and temperature when printing parts. It's self-lubricating and wear-resistant properties make it suitable for printing gears. It has a high temperature resistance with continuous temperature of parts can reach 120℃ and short-term use temperature can reach 160℃. It's surface resistance is less than 102Ω and can be used as a conductive and antistatic material. It has low shrinkage making it less susceptible to warping and cracking during printing. The printing surface finish is matte and stunning.
- Stainless steel/hardened nozzle is needed as this material is abrasive.
- Material should be dried before use; 70c
- Print Hot-end temperature: 270~300c
- Print Bed temperature: 60-80c
- Print Speed: 40~100 mm/s
16 other products in the same category
eSUN PVA is a water soluable filament which is ideal as a support material for PLA.
eSUN PLA-HS is suitable for high-speed printing, ideal for rapid prototyping where prints can achieve smooth finishes without clogging or deforming during the printing process.
eFLEX TPU has high flexibility, flexural tensile resistance, wear resistant and age resistant. The product prints with a certain degree of transparency.
eSUN Silk - a new composite PLA filament made with glossy silk appearance. Due to the elastic-like properties of this filament layers are very difficult to distinguish. It has to be seen to be appreciated.
A ShapeNerd favourite!
eSUN ePA-CF Nylon Carbon Fibre - Nylon based with 20% Carbon Fibre. High strength, High rigidity, wear resistant and it looks fantastic!
eSun ABS 3D Filament; a strong, durable filament with a low shrinkage rate. This filament CAN be acetone smoothed/welded.
eSUN Silk Mystic - a new composite PLA filament made with glossy silk appearance with a three colour gradient. Due to the elastic-like properties of this filament layers are very difficult to distinguish.
eSUN's PETG - An easy to print material with good heat resistance, strength and a little bit of flexibility.
eSUN PVA+ is a water soluable filament which is ideal as a support material for PLA, PLA+, ABS, ABS+, ABS-MAX, Nylon and others.
A Glow-in-the-dark filament with amazing vibrancy and glow!
eSUN PLA+ refill pack can be installed on your clear filament spool or you can print your own.
eSun Luminous Rainbow is a modified PLA material. It has gorgeous luminous rainbow appearance effect! The luminous effect can change based on the UV Radiation received!
The all-new PLA+ filaments are superior to all original PLA filaments. Available in a variety of colours. A great filament for prototyping and modelling.
eSUN ePLA-Gloss is an easy to print, environmentally friendly cost-effective material with a Glossy finish.