eSUN PVA+
eSUN PVA+ is a water soluable filament which is ideal as a support material for PLA, PLA+, ABS, ABS+, ABS-MAX, Nylon and others.
eFLEX TPU has high flexibility, flexural tensile resistance, wear resistant and age resistant. The product prints with a certain degree of transparency.
Special steps are required to print flexible material, regardless of vendor. It needs to be printed slow to avoid jams and clogs. Protection in the form of tape or a glue-stick needs to be done to a PEI coated bed. Failure to do so may damage your bed or make the part impossible to remove from the bed without damage.
eSUN PVA+ is a water soluable filament which is ideal as a support material for PLA, PLA+, ABS, ABS+, ABS-MAX, Nylon and others.
eSUN's PETG - An easy to print material with good heat resistance, strength and a little bit of flexibility.
eSUN Silk Mystic - a new composite PLA filament made with glossy silk appearance with a three colour gradient. Due to the elastic-like properties of this filament layers are very difficult to distinguish.
eSun PLA-ST "Super Tough PLA" offers outstanding mechanical properties while printing easily like other PLA filaments. PLA-ST filament; the perfect choice for printing mechanical part prototypes.
eSUN PLA+ refill pack can be installed on your clear filament spool or you can print your own.
A material developed by eSUN and LUVOCOM based on PA12, added with 15% carbon fiber, greatly enhances the strength, rigidity and toughness of nylon. Low water absorption rate.
eSun ePLA-LW Light Weight PLA is a new material specifically designed for printing RC Aeroplanes and other lightweight items.The foaming ratio is up to 220%!
**PLEASE NOTE NATURAL IS OUT OF STOCK ETA AT THIS STAGE IS UNKNOWN AND WE WILL KEEP PAGE UPDATED**
eSUN PVA is a water soluable filament which is ideal as a support material for PLA.
eSun Luminous Rainbow is a modified PLA material. It has gorgeous luminous rainbow appearance effect! The luminous effect can change based on the UV Radiation received!
eSUN's PETG - An easy to print material with good heat resistance, strength and a little bit of flexibility.
The all-new PLA+ filaments are superior to all original PLA filaments. Available in a variety of colours. A great filament for prototyping and modelling.
ASA is a fantastic ABS replacement. Its UV resistance is fantastic and this makes it perfect for Outdoor use.
A material developed by eSUN and LUVOCOM, greatly enhances the strength, rigidity and toughness of nylon. Low water absorption rate.
eSun ePLA-CF Carbon Fibre PLA is a new material integrating German-imported short-cut carbon fibers into PLA.
Through the modification of PLA, ePLA-Lite not only maintains the characteristics of easy printing of PLA filament, but also improves the printing performance and physical strength on the original material. This is a cost-effective alternative.
eSUN Silk - a new composite PLA filament made with glossy silk appearance. Due to the elastic-like properties of this filament layers are very difficult to distinguish. It has to be seen to be appreciated.
A ShapeNerd favourite!