The MK52 heatbed has embedded high Curie temperature magnets. These magnets are able to firmly hold removable spring steel sheets.
The Satin sheet further expands our line-up of print sheets. In terms of printing properties, the Satin sheet sits between the smooth and textured variants. Its powder-coated surface with lightly textured matte finish offers an optimal level of adhesion, especially when printing PLA and PETG materials. It is fully compatible with a wide range of common and less-common filaments, such as ABS, ASA, FlexFill 98A, Polycarbonate and more. A vast majority of materials can be printed without a separation layer (e.g. glue).
Polycarbonate - prints better on satin (compared to smooth and textured sheets) - when printing with PC often, glue stick layer is recommended to prevent possible damage to the sheet.
Find more details about the spring steel sheets (including usage and maintenance instructions) in Prusa's knowledge base.
WARNING:
Never clean the Satin powder-coated spring steel sheet with acetone! Doing so will create microfractures in the texture, which will make the surface deteriorate over time. Learn more about printing on the Satin powder-coated steel sheet in Prusa's knowledge base.
Note:
Consumable parts, such as PEI sheets (smooth, textured, etc.) are not covered by warranty as the coatings are designed to diminish over time unless failure has occurred due to a defect in materials or workmanship. Cosmetic damage, including but not limited to scratches, dents, cracks or other cosmetic damage is also not covered by the warranty. Only defective sheets on arrival are covered by warranty.
This product is the replacement Heatbed to Einsy power cable. It is ONLY compatible with the heatbeds with detachable power cable. It is NOT compatible with heatbeds with power cable soldered directly onto the heatbed.
This is Extruder Drive Gear (Motor Pinion) replacement for the Original Prusa MINI/+ extruder motor. This drive gear sits directly on the extruder motor shaft.
Prusament PLA is an in-house-made filament at Prusa Research. The whole manufacturing process is closely monitored and tested - guarantee ±0.02mm precision and highly consistent colors. You can inspect the parameters of every spool made at prusament.com.
Nozzle X from E3D's V6 line-up is recommended for printing abrasive material and at high temperatures, which causes the standard brass nozzle to wear out very quickly.
Price$59.95
Double-sided powder-coated Satin spring steel sheet for the Original Prusa Mini/Mini+.
