A high quality upgrade to a "Swiss" style hot-end.
This kit includes;
1x Heat Sink
1x Titanium Alloy heat break
1x Heat Block
1x Silicone Sock
1x 0.4mm "MK8" Brass Nozzle
2x Orange bowden tube retainer clips
2x Black bowden tube retainer/collet
1x spare grub screw for heat break
1x thermistor retaining screw
Assembly Steps: 1. Assemble the heat break into the heat-block taking care to not over-tighten as you may strip the threads in the heat block. Tighten it until it seats and give an additional 1/8th of a turn.
2. Assemble the nozzle into the heat block, taking care to not over-tighten as you may strip the brass nozzle threads or the threads in the heat block. Tighten until it seats. We'll tighten again later.
3. Unscrew the grub screw on the heat sink and slide the heat break + heat block + nozzle assembly into the heat sink. The heat break lip should sit flush/neatly against the heat sink. Tighten the grub screw, but do not over-tighten - the grub screw and/or thread will VERY easily strip if excessive force is used. It should be a little more than "finger tight".
4. Insert the black bowden collet into the top.
5. Mount the assembled hot-end onto your printer. Insert the heat cartridge, thermistor and thermistor retaining screw into the heat block.
6. Re-attach the extruder cooling fans.
7. Heat the hot-end up to 240-260c. Gently tighten the nozzle an additional 1/8th of a turn, use a spanner to hold the flat-spots on the heat break as you tighten. Take care to avoid burning yourself on the hot-end!
8. Allow the nozzle to cool and check all your work.
9. Print something amazing!
It's not recommended to install the 2x long screws between the heat block and heat sink. These screws only assist in heat-creep and may result in clogs.
If using a bowden style machine, recommended starting settings for retraction are 2.5-4mm and a retraction speed of 80mm/s or more. If you find that your printer is unable to retract fast enough, you may need to override your firmware with a GCODE command "M203 E200".
E3D Online have developed this Revo-compatible HeatSink in collaboration with Team Voron. It’s intended for use with the Voron StealthBurner, which includes an integrated cold side fan. (Note: This means this kit will ship without a fan!)
These retention springs clip onto your Revo™ HeaterCore on one side, before connecting to any Revo-compatible cold side on the other – including the Revo Micro, Revo Six, and Revo Hemera. The spring keeps the HeaterCore firmly attached to the cold side, while pushing it into the nozzle for improved thermal conductivity.
Features:
Keeps the HeaterCore into good thermal contact with a Revo Nozzle
Effective in attaching Revo HeaterCore to heatsink
Compatible with Revo Micro, Revo Six, and Revo Hemera
This is a replacement heatsink for Revo™ Six. It retains the same dimensions as the E3D V6 – including height, diameter, and groove mount – so any printer with a V6 setup can use it without a print head redesign.
Features:
Compatible with 1.75mm filament
Anodised black aluminum heatsink keeps things cool and looks cool too
Identical height, diameter, and groove mounting to E3D V6 for drop-in upgradability
