A material developed by eSUN and LUVOCOM, greatly enhances the strength, rigidity and toughness of nylon. Low water absorption rate.
A material developed by eSUN and LUVOCOM, greatly enhances the strength, rigidity and toughness of nylon. Due to it's low water absorption rate it's less affected by humidity and temperature when printing parts. It's self-lubricating and wear-resistant properties make it suitable for printing gears. It has a high temperature resistance with continuous temperature of parts can reach 120℃ and short-term use temperature can reach 160℃. It's surface resistance is less than 102Ω and can be used as a conductive and antistatic material. It has low shrinkage making it less susceptible to warping and cracking during printing. The printing surface finish is stunning.
ASA is a fantastic ABS replacement. Its UV resistance is fantastic and this makes it perfect for Outdoor use.
eSun ePLA-LW Light Weight PLA is a new material specifically designed for printing RC Aeroplanes and other lightweight items.The foaming ratio is up to 220%!
**PLEASE NOTE NATURAL IS OUT OF STOCK ETA AT THIS STAGE IS UNKNOWN AND WE WILL KEEP PAGE UPDATED**
eSun Marble PLA 3D print filament is a composite PLA filament with marble-like appearance.
eSun ABS+ 3D Filament is an optimised ABS filament to print with significantly less warping than other regular ABS filaments.
The all-new PLA+ filaments are superior to all original PLA filaments. Available in a variety of colours. A great filament for prototyping and modelling.
eSUN's PETG - An easy to print material with good heat resistance, strength and a little bit of flexibility.
eSUN PLA+ refill pack can be installed on your clear filament spool or you can print your own.
eSUN ePA-CF Nylon Carbon Fibre - Nylon based with 20% Carbon Fibre. High strength, High rigidity, wear resistant and it looks fantastic!
eSUN Silk Magic - a new composite PLA filament made with glossy silk appearance in two tone. Due to the elastic-like properties of this filament layers are very difficult to distinguish. It has to be seen to be appreciated.
The all-new PLA+ filaments are superior to all original PLA filaments. Available in a variety of colours. A great filament for prototyping and modelling.
eSUN Polycarbonate filament is perfect to be used to build structural or fire resistant parts.
eSUN Silk - a new composite PLA filament made with glossy silk appearance. Due to the elastic-like properties of this filament layers are very difficult to distinguish. It has to be seen to be appreciated.
A ShapeNerd favourite!
eSUN ePLA-Gloss is an easy to print, environmentally friendly cost-effective material with a Glossy finish.
eSUN's PETG - An easy to print material with good heat resistance, strength and a little bit of flexibility.
eSun ePLA-CF Carbon Fibre PLA is a new material integrating German-imported short-cut carbon fibers into PLA.
eSUN PVA+ is a water soluable filament which is ideal as a support material for PLA, PLA+, ABS, ABS+, ABS-MAX, Nylon and others.
A material developed by eSUN and LUVOCOM, greatly enhances the strength, rigidity and toughness of nylon. Low water absorption rate.
