eSUN PVA is a water soluable filament which is ideal as a support material for PLA.
eSUN ePA12 Nylon
A material developed by eSUN and LUVOCOM, greatly enhances the strength, rigidity and toughness of nylon. Low water absorption rate.
A material developed by eSUN and LUVOCOM, greatly enhances the strength, rigidity and toughness of nylon. Due to it's low water absorption rate it's less affected by humidity and temperature when printing parts. It's self-lubricating and wear-resistant properties make it suitable for printing gears. It has a high temperature resistance with continuous temperature of parts can reach 120℃ and short-term use temperature can reach 160℃. It's surface resistance is less than 102Ω and can be used as a conductive and antistatic material. It has low shrinkage making it less susceptible to warping and cracking during printing. The printing surface finish is stunning.
- Stainless steel/hardened nozzle is needed as this material is abrasive.
- Material should be dried before use; 70c
- Print Hot-end temperature: 260~290c
- Print Bed temperature: 70-90c
- Print Speed: 40~100 mm/s
16 other products in the same category
Through the modification of PLA, ePLA-Lite not only maintains the characteristics of easy printing of PLA filament, but also improves the printing performance and physical strength on the original material. This is a cost-effective alternative.
eSUN ePLA-Gloss is an easy to print, environmentally friendly cost-effective material with a Glossy finish.
eSUN PVA+ is a water soluable filament which is ideal as a support material for PLA, PLA+, ABS, ABS+, ABS-MAX, Nylon and others.
eSun PLA-ST "Super Tough PLA" offers outstanding mechanical properties while printing easily like other PLA filaments. PLA-ST filament; the perfect choice for printing mechanical part prototypes.
eSUN's PETG - An easy to print material with good heat resistance, strength and a little bit of flexibility.
eSun ABS 3D Filament; a strong, durable filament with a low shrinkage rate. This filament CAN be acetone smoothed/welded.
A PLA Based filament with Glow-in-the-dark star-like appearance!
ASA is a fantastic ABS replacement. Its UV resistance is fantastic and this makes it perfect for Outdoor use.
A material developed by eSUN and LUVOCOM based on PA12, added with 15% carbon fiber, greatly enhances the strength, rigidity and toughness of nylon. Low water absorption rate.
eSUN Polycarbonate filament is perfect to be used to build structural or fire resistant parts.
eSun ePLA-LW Light Weight PLA is a new material specifically designed for printing RC Aeroplanes and other lightweight items.The foaming ratio is up to 220%!
**PLEASE NOTE NATURAL IS OUT OF STOCK ETA AT THIS STAGE IS UNKNOWN AND WE WILL KEEP PAGE UPDATED**
The all-new PLA+ filaments are superior to all original PLA filaments. Available in a variety of colours. A great filament for prototyping and modelling.
eSun ePLA-CF Carbon Fibre PLA is a new material integrating German-imported short-cut carbon fibers into PLA.
eSun ABS+ 3D Filament is an optimised ABS filament to print with significantly less warping than other regular ABS filaments.