Product Features
eLastic Resin, Compatible to most LCD printers and DLP with LED UV.
Good elasticity
Tear and Bend resistance
High toughness
Low hardness and viscosity 

Resin parameters
Hardness (D): 70A
Viscosity (25C,mPa.s): 500 to 900 mpa.s
Density: 1.08 to 1.085 g / cm3

Physical Properties
Tearing strength (GPa): 8GPa to 10GPa
Tensile strength (Mpa): 4-5 Mpa
Elongation at break (%): 250% to 350%
Hardness (D): 70A

Precautions

Storage

1) Keep away from light and sealed at room temperature.
2) It is recommended to store the resin between 15 Celsius and 35 Celsius in its original container.
3) Avoid any dusty or moist environment.

Usage

Shake well before use. Avoid any direct sunlight during usage.
Keep away from the children.
Do not drink, do not put in mouth.
Wear gloves and safety equipment.
Avoid direct contact with the skin.
Use only in a well ventilated room.
If product comes in contact with skin, please wash with plenty of water immediately. Seek medical advice immediately if necessary.
Finished models are required to clean by high-concentration alcohol (>95%) for about 30 seconds.