• Out of Stock.
eSUN PMMA-Like PM200 Resin 1 Litre
  • eSUN PMMA-Like PM200 Resin 1 Litre

eSUN PMMA-Like PM200 Resin 1 Litre

inc GST

eSun PMMA-Like PM200 3D Print Resin is specifically designed for high transparency and anti-yellowing after printing and exposure to irradiating ultraviolet rays. 

Out of Stock.

Product Features
Compatible to most LCD printers and DLP with LED UV.
High Hardness 78 shore D, Low Shrinkage
High Transparency

Resin parameters
Hardness (D): 78D
Viscosity (25C,mPa.s): 200 to 600 mpa.s
Density: 1.05 to 1.15 g / cm3

Physical Properties
Flexural strength (Mpa): 35Mpa to 56Mpa
Elongation at break (%): 32% to 40%
Hardness (D): 78D



1) Keep away from light and sealed at room temperature.
2) It is recommended to store the resin between 15 Celsius and 35 Celsius in its original container.
3) Avoid any dusty or moist environment.


Shake well before use. Avoid any direct sunlight during usage.
Keep away from the children.
Do not drink, do not put in mouth.
Wear gloves and safety equipment.
Avoid direct contact with the skin.
Use only in a well ventilated room.
If product comes in contact with skin, please wash with plenty of water immediately. Seek medical advice immediately if necessary.
Finished models are required to clean by high-concentration alcohol (>95%) for about 30 seconds.


Specific References